Power Supply Board for HP LaserJet P1007 / P1008 Original Imported

Original Power Supply Board for HP LaserJet P1007 / P1008 — Imported

Get your HP LaserJet back to life with the PRM Original Power Supply Board. This is a genuine original board — not a compatible copy — sourced from original equipment and imported directly. One board fits both the P1007 and P1008.

Looking for an HP P1007 power supply or HP P1008 power board? This is the correct power supply board for both printers.

When Do You Need a New Power Supply Board?
The power supply board converts mains AC power into the regulated DC voltages that run every component inside your printer — the formatter, fuser, and motor. When it fails, the entire printer is affected. Replace your power supply when you see:
- Printer completely dead — no lights, no response when pressing the power button
- Printer turns on briefly then shuts off immediately
- Random shutdowns during printing — printer dies mid-job
- Fuser error or 50.x error — the power supply feeds the fuser heater; a weak supply causes temperature errors
- Burning smell from the power supply area (not from the fuser)
- Printer takes unusually long to warm up or never reaches ready state
- Error lights blinking in a pattern that indicates a power fault
- Tripping your office power switch when the printer turns on

If you've checked the power cable, tried a different wall socket, and the printer still won't power on or keeps shutting down — the power supply board is almost certainly the cause.

1. Fits Both P1007 and P1008: One power supply board works across both the HP LaserJet P1007 and P1008. Same board, same connectors — works in either printer.

2. Original, Not Compatible: This is a genuine original HP power supply board — the same board that came inside your printer from the factory. Original boards offer exact voltage regulation and long-term reliability that compatible copies cannot match. For a critical component like the power supply that feeds every part of your printer, original is the right choice.

3. Fixes the "Dead Printer" Problem: The most common power supply failure symptom is a completely dead printer — no lights, no response. The P1007 and P1008 are compact, reliable printers found in homes and small offices across India. Before you discard a perfectly good printer, a power supply replacement brings it back to life for a fraction of the cost of a new printer.

4. Resolves Fuser Errors Without Replacing the Fuser: Many fuser errors on the P1007/P1008 are actually power supply problems — the board can't deliver enough power to heat the fuser properly. If you've already replaced the fuser and still get temperature errors, the power supply is the fix.

5. Easy Installation: Disconnect the printer from mains power, remove the side panel, unplug the connectors from the old power supply board, swap in the new one, reconnect all cables, and reassemble. 20-30 minutes for any printer technician. Basic screwdriver needed.

6. Tested Before Shipping: Every PRM power supply board is tested for correct voltage output before dispatch. Backed by our testing warranty.

Compatible Printers:
HP: LaserJet P1007, LaserJet P1008

Also known as: HP P1007 Power Supply, HP P1008 Power Board, HP P1007 Power Supply Board, HP P1008 SMPS Board, HP P1007 SMPS, HP P1008 Power Supply