Power Supply Board for HP LaserJet 1020 / Canon LBP 2900 Original Imported

Original Power Supply Board for HP LaserJet 1020 / Canon LBP 2900 — Imported

Get your printer back to life with the PRM Original Power Supply Board. This is a genuine original board — not a compatible copy — sourced from original equipment and imported directly. One board fits both the HP LaserJet 1020 and Canon LBP 2900.

Looking for an HP 1020 power supply or Canon LBP 2900 power board? This is the correct power supply board for both printers.

When Do You Need a New Power Supply Board?
The power supply board converts mains AC power into the regulated DC voltages that run every component inside your printer — the formatter, fuser, and motor. When it fails, the entire printer is affected. Replace your power supply when you see:
- Printer completely dead — no lights, no response when pressing the power button
- Printer turns on briefly then shuts off immediately
- Random shutdowns during printing — printer dies mid-job
- Fuser error or 50.x error — the power supply feeds the fuser heater; a weak supply causes temperature errors
- Burning smell from the power supply area (not from the fuser)
- Printer takes unusually long to warm up or never reaches ready state
- Error lights blinking in a pattern that indicates a power fault
- Tripping your office power switch when the printer turns on

If you've checked the power cable, tried a different wall socket, and the printer still won't power on or keeps shutting down — the power supply board is almost certainly the cause.

1. Fits Both HP 1020 and Canon LBP 2900: One power supply board works across both the HP LaserJet 1020 (including 1020 Plus) and Canon LBP 2900 / 2900B. Same board, same connectors — works in all of these printers.

2. Original, Not Compatible: This is a genuine original power supply board — the same board that came inside your printer from the factory. Original boards offer exact voltage regulation and long-term reliability that compatible copies cannot match. For a critical component like the power supply that feeds every part of your printer, original is the right choice.

3. Fixes the "Dead Printer" Problem: The most common power supply failure symptom is a completely dead printer — no lights, no response. The HP 1020 and Canon LBP 2900 are legendary workhorses that often run for 10+ years. Before you discard a perfectly good printer, a power supply replacement brings it back to life for a fraction of the cost of a new printer.

4. Resolves Fuser Errors Without Replacing the Fuser: Many fuser errors on the 1020/LBP 2900 are actually power supply problems — the board can't deliver enough power to heat the fuser properly. If you've already replaced the fuser and still get temperature errors, the power supply is the fix.

5. Cross-Brand Compatibility: The HP LaserJet 1020 and Canon LBP 2900 share the same power supply design. Many internal components are identical across these printers. One board covers both — no need to search for brand-specific parts.

6. Easy Installation: Disconnect the printer from mains power, remove the side panel, unplug the connectors from the old power supply board, swap in the new one, reconnect all cables, and reassemble. 20-30 minutes for any printer technician. Basic screwdriver needed.

7. Tested Before Shipping: Every PRM power supply board is tested for correct voltage output before dispatch. Backed by our testing warranty.

Compatible Printers:
HP: LaserJet 1020, LaserJet 1020 Plus, LaserJet 1018
Canon: LBP 2900, LBP 2900B

Also known as: HP 1020 Power Supply, Canon LBP 2900 Power Board, HP 1020 Power Supply Board, Canon 2900 Power Board, HP 1020 SMPS Board, Canon LBP 2900 SMPS, RM1-2316